Very Slow Progress

1. Rear Wing after Initial Polishing. A little Chrome effect shown


2. Engine Core
Step 1 (Glossy Black)


Step 2 (Super Stainless)


Step 3 (Washed with Smoke)


3. Ready for Plus
0.4 mm diameter for each connection point. There will be 13 Spark Plus cord connecting to this small part


4. Ready for Tube
Once again. There will be 12 Tube connecting to the V12 Engine


5 Brake Disks (5 in one by using PE)



Long long way to go

[ Last edited by DMAN on 2006-9-19 at 02:50 AM ]

[ 本帖最後由 DMAN 於 2007-1-7 03:11 AM 編輯 ]

我睇唔到d 圖

yeh cross bun for me too
try to fix it bro

I could view those yahoo link at my home. Anyway, I have just changed to Photo Bucket

Great job, DM  
The super stainless and smoke wash gives a good result on the engine.
Keep up for posting more progress pics.
I would stay tune on this threat definitly.

yeh, the engin looks really realistic after the wash
good job man
keep up the good work

the engine looks so real~~~

wa wa wa ....
GREAT JOB

keep on man

Update 22 August, 2006

Wiring
This is the Plus Cord coming with the kit. However, it doesn't look like a Plus Cord at all.


The effect is not very good if this cord is being used.


Instead, I have used a substitution from MSM Creation. This is much better than the one coming with the kit.


However, the diameter of Plus Cord from MSM Creation is about 0.48mm. All holes for connection have to be drilled again. 0.5 mm should be perfect.


Hopefully, will move to the connection of oil tubes real soon !

可不可看看Body和其他部件？？未作任何工作也可。Thanks

個BRAKE DISK點整架?好勁呀.....

It is something like that.

終於有人砌312T3啦.......
engine will add more detail 嗎 ?

p.s. this is not V12 engine.........it is Boxer 12.......

係呀...T3發功了...
喂...Andriy砌大T啦

現在砌緊MIG-29呀......大T慢慢來啦......

我想知架車係辺個Ｍａｋｅｒ出？？

Update 25 Aug, 2006

Oil Tube Connection.

I have been stuck in this step for couple days already.
The original design is using the L-Shape hook connecting with the OIL TUBE provided with the kit. However, there are 2 problems
1. I have tried many glue but not working for the tube and the L-Shape hook very well.
2. The provided tube is not flexiable but HARD. When I bend it a little bit, it will detacted from the L-Shape hook.
See Step 2 and Step 3

[img][/img]

So, DIY seems to be the only solution. The OIL TUBE have to be planted inside the part.
The part is about 3mm x 4mm. For the substitute, FISH WIRE is a good choice since it is CLEAR in color and also more flexible.


Hofefully, those OIL TUBE would be connected to the cylinders on tomorrow.

Take a guess, how many OIL TUBES have been connected in the picture ?

[ Last edited by DMAN on 2006-8-25 at 02:13 AM ]

Update 26 Aug, 2006
Damned tired now

Wing Part PE assembly Step





Fitting Test

how amazing you are!!!
very great job!!!