原帖由 woo 於 2008-9-9 01:07 AM 發表
要用一字縲絲批(mm計)加熱6-7秒.慢慢篤入去.
記住唔好太熱,否則附近受熱就麻煩了.
等一陣乾左後,磨走突起部分就ok.
呢個方法只限一少劃.長線就唔得,可能要用推刀之類..
thanks for the tips!i used the exact same method, but i think maybe i push too hard and old hands not steady enough.
hahaha good idea, buy second hand... maybe i should do that for my B3....the problem is always weather to buy a second hand to complete it or wait for ver. 2?....
the NT-1 is looking good, i didnt bought the MG when it was released bcos the head was too big
!! plus the legs is like a log of wood.
i think you've done a good job on the NT-1, not sure if its needs to buff up, but i think i also like the contrast when it was its full armour on and when its just a MS. please update more, you're very patient and have steady hands, also can sense you spend a lot of time on sanding!!!! which always gives good results!
分享
