Ready to Start. I hope it could be completed in about 2 months


[ 本帖最後由 DM 於 2010-9-12 02:20 PM 編輯 ]

I wanted to build 328 at beginning. However, the PE has not released yet. So, I am going for this one first. However, I am still working on the information gathering

Let me get the PE first la. You got at least 99 yrs

I am not sure the CM will have it or not. However, the one from S27 has just released. Since there is a PE included in the model already, the only useful parts are the wipers and brake disk only




[ 本帖最後由 DM 於 2007-3-2 11:17 PM 編輯 ]

I will try to share a little experience about building Multimedia kit this time. This is not a LECTURE (I hate giving people a lecture). But it is just a little sharing. If I have made anything wrong, please feel free to correct me.

Very First Step of Building Multimedia Kit ---- COUNTING PARTS (點件). Unlike, Tamiya or other injection kit, those Multimedia Kit is packed but hands. So, anything could happen.


Since most of the White Metal parts are DIRTY, they have to be CLEANED. There are some METAL BRUSH (鋼絲擦) or METAL SPONGE for cleaning those WHITE METAL PART.


After brushing, you may see the different


Before Cleaning and After Cleaning


[ 本帖最後由 DM 於 2007-3-4 12:37 AM 編輯 ]

Test Fitting is very important for building Multi Media Kit. In order to assemble parts together, some extra job may be required.


In order to glue parts together, general glue/cement for Plastic/Injection won't work. So, Epoxy or Solder are the solution. However, Epoxy is easier to handle and less dangerous to you and your kit.



For Surface, general surfacer for Injection kit is not recommended. So, Metal Primer or Surfacer for Auto(car) are good choices

Soft99 Primer is good for RESIN and Metal kit only. Don't use it for Plastic kit

I have no idea on that issue. You may want to do a little experiment on some junk kit. However, I would use FINISHERS color instead of such real car paint

唔會變 [好 不人精] 掛

[ 本帖最後由 DM 於 2007-3-4 02:22 AM 編輯 ]

This is hard to say. I had some drill bit and thery were working for plastic before. However, they were down when drilling White Metal

咁你即係叫我走佬o即 !

I think that you are right. The material of the drill bit is not good enough. However, they were OK for the plastic b4. So, I just simply assumed the White Metal is harder than plastic

After that, I went to get a set from Tamiya and it was kinda expensive but it works for White Metal wor.

[ 本帖最後由 DM 於 2007-3-4 12:38 PM 編輯 ]

Don't count on me. I may be wrong and "OLD POINT"

Just a little sharing and take it easy on that

Thanks for your tips. I really have no clue on that before. By the way, for soldering, do you have any tips for us such as melting point ?

I use to use the one from Apliu Street. HKD3 per each. However, for some small size such as 0.3mm, the one from Apliu street is not working very well and I just got the set from Tamiya

唔 Sure 喎
但我用鴨記3蚊支果 D 0.3mm, 3野玩完[頓]野, Tamiya 果 D冇事

啤 ~~~~~~~~~~~~~~~~~~~~~

睇怕有排改

原本果個真是 Simple 左d